Product Details
Low total alkalinity (TA) may cause pool water to be corrosive and the pH level difficult to maintain. Total alkalinity should be maintained at between 80 - 150mg/l (ppm). Test the total alkalinity level of the pool water and if it is below 80mg/l (ppm) use Pak 1 to increase the level.
Application Instructions
1. Pre-dissolve the product in a clean plastic container at a maximum rate of 100g of product per 2.2 gallons (10lts) of clean water. Stir well to ensure product is fully dissolved. Add the resulting solution to the pool whilst the pump(s) are turned "on", preferably near to the water inlets to aid distribution.
2. The total amount of TA Raiser can be applied in one application.
|
Water Volumes Dose Rates
|
|
Litres
|
Gallons
|
To increase total alkalinity by 10mg/l(ppm)
|
To increase total alkalinity by 25mg/l (ppm)
|
|
4,545
|
1,000
|
81g
|
203g
|
|
9,090
|
2,000
|
162g
|
405g
|
|
22,700
|
5,000
|
405g
|
1.01kg
|
|
45,450
|
10,000
|
810g
|
2.02kg
|
|
68,175
|
15,000
|
1.21kg
|
3.03kg
|
General Precautions
Dosing
- Wear eye and face protection and ensure granules are not blown back into your face.
- Never mix with other chemicals including household cleaners as a dangerous reaction may occur.
- When pre-dissolving always add product to water and not vice versa.
Handling/Storage
- Handle products in a well ventilated area - preferably outdoors.
- Wash hands after use.
- Ensure chemicals do not become damp in storage - store in a cool dry place.
