The Swim Pace Display can be placed wherever it is convenient and visible to the swimmer. It is weather resistant, though reliability is enhanced if it is placed in a somewhat protected location free from frequent or heavy rainfall.
The large, bright LED characters and non-glare face are well suited for use in direct sunlight, but visibility is improved when the unit is mounted in shade. The display brightness can be reduced for indoor use. The display unit should be mounted near the pool where it is easily visible while swimming. The Velcro mounting tape allows you to attach the unit to virtually any surface.
The Swim Pace Display gets its signal and power through a standard phone cord from the controller. Make sure your mounting location allows you to route the phone cord easily from the controller. Additional 4- conductor phone cord and coupling connectors may be purchased at any electronics supply store if more length is needed.
The model of Fastlane can be found on the main power unit inside the electrical cabinet.
Swim Pace Display Kit
- Swim Pace Display unit
- 14” of Velcro tape
- 50’ of phone cord
- Water-tight enclosure fitting
- Reducing bushing
If you are unsure if you have an EP1 or EP3 model, you can identify which one by checking the control box, the EP1 control box has 1 screw holding the cover on, the EP3 control box has a set of 4 screws securing it.