Aquasparkle TA Plus Bicarbonate Of Soda (Raises Total Alkalinity)

Low total alkalinity (TA) may cause spa water to be corrosive and the pH level difficult to maintain. Total alkalinity should be maintained at between 80 - 150mg/l (ppm). Test the total alkalinity level of the spa water and if it is below 80mg/l (ppm) use Aquasparkle Spa TA Plus to increase the level.

Application Instructions

1. Pre-dissolve the product in a clean plastic container at a maximum rate of 10g of product per 0.2 gallons (1lt) of clean water. Stir well to ensure product is fully dissolved. Add the resulting solution to the spa whilst the pump(s) are turned "on", preferably near to the water inlets to aid distribution.
2. The total amount of Spa TA Plus can be applied in one application.
   
   

General Precautions

Dosing

• Wear eye and face protection and ensure granules are not blown back into your face.
• Never mix with other chemicals including household cleaners as a dangerous reaction may occur.
• When pre-dissolving always add product to water and not vice versa.

Handling/Storage

• Handle products in a well-ventilated area, preferably outdoors.
• Ensure lid is replaced and sealed after use.
• Ensure chemicals do not become damp in storage - store in a cool, dry place.
• Wash hands after use.